NXP Semiconductors i.MX6UltraLite, Quick Start Manual

Page: 13 / 21

NXP Semiconductors
AN12397
EdgeLock
TM
SE050 Quick start guide with i.MX6UltraLite
AN12397 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2019. All rights reserved.
Application note Rev. 1.2 — 17 December 2019
534512 13 / 21
4 Run EdgeLock SE050 Plug & Trust middlewaretest examples
The EdgeLock SE050 Plug & Trust middleware comes with several test examples used
to verify atomic EdgeLock SE050 security IC features. This section explains how to run
the EdgeLock SE050 Plug & Trust middleware test example called
se05x_minimal.
1. Go to se050_mw_vXX.XX.XX_build/imx_native_se050_t1oi2c/bin directory as
shown in Figure 12 , where vXX.XX.XX corresponds to the EdgeLock SE050 Plug &
Trust middleware version number. At the moment of writing, the latest version was
v02.09.00_20190605_115623
Send > cd se050_mw_vvXX.XX.XX_build/imx_native_se050_t1oi2c/bin .
Figure 12. Go to the EdgeLock SE050 Plug & Trust middleware test example
directory
2. Execute the
se05x_minimal
test example. This test example outputs the memory
left in EdgeLock SE050 security IC.
Send > ./se05x_minimal .
The TeraTerm logs should indicate the available memory in EdgeLock SE050 security
IC as can be seen in Figure 13 (in this case, 592).
Figure 13. Run se05x_minimal test example
The execution of the se05x_minimal project is shown as an example. The steps
detailed in this section can be replicated to run any other test example included as part of
the EdgeLock SE050 Plug & Trust middleware. To get the list of test examples:
1. Send the
ls command as shown in Figure 14