5
4
Step-by-Step
Installation Instructions
In this Quick Start Guide, you will learn how to set up the
TWR-K60N512-KEIL
board and
run the default demonstration.
1
Install the Software
and Tools
Install the P&E Micro Kinetis Tower Toolkit
before installing the OSJTAG and USB-to-
Serial drivers. These can be found on the
DVD under Software.
2
Configure the
Hardware
Install the included battery into the VBAT
(RTC) battery holder. Then, connect one
end of the USB cable to the PC and the
other end to the Power/OSJTAG mini-B
connector on the
TWR-K60N512-KEIL
module. Allow the PC to automatically
configure the USB drivers if needed.
3
Tilt the
Board
Tilt the board side to side to
see the LEDs on E1–E4 light up as it is
tilted. While the board is held flat, touch the
pads on E1–E4 to toggle the LEDs.
4
Play the
Memory Game
Press
SW2
to play a memory recall game
using the touch pads
E1–E4
. A sequence
will light up, then press the touch pads
in the order flashed. If an incorrect
sequence is touched or too much time
has elapsed, all the lights will blink
rapidly and the game will reset.
Press
SW1
to go back to the
accelerometer demo.
5
Explore Further with the
ARM
®
Keil
®
Quick Start
Guide
Learn how to install the Keil MDK tools
and run a variety of examples on the
TWR-K60N512-KEIL
by following the
step-by-step instructions in the Keil Quick
Start Guide found on the DVD included in
the
TWR-K60N512-KEIL
kit.
6
Learn More
About the Kinetis
K60 Microcontrollers
Find MQX
TM
RTOS and more bare-metal
labs and software for the Kinetis K60
microcontrollers at
freescale.com/
towerkeil
.
Downloaded from
Downloaded from
Downloaded from
