NXP Semiconductors Freedom FRDM-KV11Z, User Manual, Page: 14 / 20

Reset
FRDM-KV11Z Evaluation Board Users Guide
14 NXP Semiconductors
9. CAN serial interface
The CAN interface signals are PTE24/CAN0_TX and PTE25/CAN0_RX. They are connected to an on-
board transceiver for buffering on to header J9(not populated).
Figure 14. CAN interface circuit
10. Reset
The RESET signal is low active on all Kinetis MCUs. The KV11Z Reset signal is connected to the
debug K20 MCU and a button SW1. If the J10 jumper is between 1-2 the KV11 Reset is driven by the
output of the level translator. This is needed if the debug MCU and the target KV11 MCU are at
different VDD levels, such as when an external 1.8 V DC VDD is provided to the KV11 MCU.