NXP Semiconductors EasyEVSE EV, User Manual

Page: 13 / 64

Table 1. EasyEVSE required parts (continued)
Required part Product page Description Picture
TWR-KM34Z75M Tower System Development Board for
Kinetis KM14, KM33, and KM34 (50
MHz) MCUs
TWR-KM34Z50M Tower System Development Board for
Kinetis KM14, KM33, and KM34 (50
MHz) MCUs.
CLEV6630ARD CLEV6630ARD CLEV6630ARD: NFC frontend
CLRC663 plus Arduino interface board
RK043FN02H-CT 4.3­
inch TFT 480*272 LCD RK043FN02H-CT: 4.3"
LCD Panel The RK043FN02H-CT is a 4.3-inch
TFT 480*272 display manufactured by
Rocktech Displays Limited.
3.2 Miscellaneous hardware
Table 2 lists the miscellaneous hardware required by the EVSE.
Table 2. Miscellaneous hardware
Description Purpose Reference picture Example of supplier buy link
RJ45 Ethernet UTP cable Provide internet connection to
the EVSE. Newark Ethernet Cable,
Cat5e, Cat5e, 2.1 m, 7 ft,
RJ45 Plug to RJ45 Plug, Blue
2.54-mm jumper cables:
• A set of 3-pin male-to­
female cables.
• 2 independent male-to­
male cables.
Connect the i.MX RT106x
and the TWR-KM3x
UART interface.
Re-map the IRQ and
nPDOWN pins of the
CLRC663 ARD board. Newark Jumper Wire Kit, Male
to Male, Multi-Colored, 200
mm, 0.1" Dupont Connector,
0.2 mm²
Jumper Wire Kit, Male to
Female, Multi-Colored, 100
mm, 0.1" Dupont Connector,
0.2 mm²
Table continues on the next page...
NXP Semiconductors
Required hardware
NXP EasyEVSE EV Charging Station Development Platform User Guide, Rev. 0, 18 March 2022
User Guide 13 / 64