8 Demonstration
1. Build and compile the project.
2. Plug one side of USB cable in PC USB port and another side in the debug link port in the EVK board, and then
download the image in the MCU.
3. Connect camera to MCU by referring to connection of interface in Chapter 4.
4. Connect the LCD panel with Arduino port on the LPCXpresso55s69 EVK board.
5. Connect one side of USB cable to USB power socket and the other to 5 V Power only USB port P5.
6. The LCD displays the video frame from camera as shown in
.
If the code cannot execute after downloaded, one of the reasons is that the MCU goes to ISP mode. The root cause
is that camera module generates logic level signal on P0.5 pin during MCU is under reset state. The solutions can
be as below:
1. Disconnect the pin before reset and connect it after reset.
2. Power down the camera module before reset and power up after reset.
WARNING
Figure 4. Video frame
NXP Semiconductors
Demonstration
Camera Interface in LPC55(S)xx, Rev. 3, 07 September 2021
Application Note
7 / 9
