nxgtechnology.com
5
Hooking it up
You can connect your TV or other external device to the Sound bar in several ways:
ANALOG Wired Connection
1. Plug the 3.5mm end of either the RCA Audio Cable or the 3.5mm Audio Cable into the
AUX IN
located on the back of the Sound bar.
2. Plug the other end into the source device (TV, Phone, MP3 Player, etc.).
3. Press the
SOURCE
button repeatedly to select
AUX
as the input.
4. Once the device is hooked up, you can control playback as you would usually on the
source device.
DIGITAL Optical Connection
(cable not supplied)
1. Connect a Digital Optical Audio Cable (also known as a TOSLINK cable) to the optical
output on the audio source and to the
OPTICAL INPUT
on the sound bar.
2. Press the
POWER
button to power the unit on.
3. Press the
SOURCE
button repeatedly to select
OPTICAL
as the input.
BLUETOOTH
1. Press the
SOURCE
button repeatedly to select the
BT
input.
2. The
BT
blue LED will flash 3 seconds and then stop for 30 seconds while it searches for
the last paired device.
3. If there is no device found, the blue LED will flash again. At this time, you can pair with
a new device.
4. Turn on the Bluetooth enabled device you want to connect and make sure Bluetooth
is turned on and searching for other Bluetooth devices (refer to the instructions for the
source device if needed).
5. The Sound bar will show up as
SB40
, select it and enter password
0000
to connect.
6. If the initial set up connection is successful, the next time the speaker is turned on, the
speaker will automatically pair to the last device it was connected with.
7. If there is no Bluetooth enabled device found, the BT blue LED will continue to flash.
NOTES:
1. The Sound bar only connects to one device at a time.
2. Turn off the Sound bar in order to pair it with another Bluetooth enabled device.
3. The reception range for the Sound bar is a standard 10 meters / 32 feet.
4. Interference may occur during playback when using the Bluetooth connection near
other wireless devices. If playback through Bluetooth is problematic, move the Sound
bar and the audio device to a different location, or use a hard-wired connection.
Audio from the connected & selected audio source will be played through the sound bar.
Press the MUTE button to turn the sound off. Press it again to return to the previous volume
level.
Summary of Contents for nx-soundbar-40
Page 2: ......
