NVX BE-LEX-IS0613-VCW104B.O.O.S.T Installation Manual Download Page 2

Step 1

  A)

  Remove the mounting screws from VCW 

woofer. Keep mounting screws in a safe 
place these will be used in the last step.

  B)

  Remove woofer from B.O.O.S.T. 

enclosure.

Step 2

  A)

  Remove all contents from the trunk.

  B)

  Remove the two cargo net hooks indicated 

by the arrows in the picture.

  C)

  Remove panel clip

Step 3

      Pull back panel to access the mounting 

bracket as seen in the picture.

 

Step 4

      Using a step drill bit slowly open the hole 

to 7/16”. Be sure to drill slowly to avoid 
bending or twisting the factory mounting 
bracket.

Step 5

  A)

  Insert supplied Jack Nut into the 7/16” 

hole that was created in the last step.

  B)

  With a pair of needle nose pliers grip the 

end of the Jack Nut while slowly tightening 
the supplied 10mm bolt to collapse the 
jack nut into place. Remove the 10mm bolt 
after the Jack Nut is fully collapsed.

Step 6

      Run speaker wire from the amplifier 

location to the B.O.O.S.T. enclosure and 
attach the speaker wire to the terminal 
positive and negative terminal. Position the 
B.O.O.S.T enclosure into place and prepare 
hardware for mounting the enclosure.

Step 7

      From inside the enclosure, place the 

supplied shorter 10mm bolt and washer 
used to collapse the Jack Nut to secure the 
first mounting point on the enclosure. 
This may require pressure against the 
enclosure to line up and thread the 10mm 
bolt into the Jack Nut. 

(Tighten till snug)

Step 8

Step 9

      From inside the enclosure, place the 

supplied longer 10mm bolt and washer 
to mount the second and last mounting 
location. This may require pressure against 
the enclosure to line up and thread the 
10mm bolt to into the floor mount. 

(Tighten till snug)

      With the enclosure mounted you will now 

reinstall the woofer from Step 1. The 
woofer will already be pre-wired for the 
installation. Be sure to connect positive to 
positive and negative to negative. Line up 
the woofer with the pre-drilled holes in the 
enclosure. Using the screws from Step 1 
tighten the woofer down in a star pattern till 
they are nice and snug. 

(Do not over tighten 

and strip the pre-drilled holes)

Reviews: