NV1023 SDIF-2 Distribution Amplifier 7
2. CONFIGURATION AND INSTALLATION
CAUTION: IF YOU ARE INSTALLING FR1000 FRAMES AND PS2001
POWER SUPPLIES IN ADDITION TO NV1023
DISTRIBUTION AMPLIFIERS AT THIS TIME, YOU
SHOULD FOLLOW THE SYSTEM-LEVEL
INSTALLATION PROCEDURES FOUND IN THE NV1000
TERMINAL EQUIPMENT OPERATIONS INSTRUCTION
MANUAL (MANUAL PART NO. MI1000-01) LOCATED IN
THE FRONT OF THIS BINDER.
CAUTION: REMOVE POWER FROM THE FRAME IF THE
INSTALLATION INCLUDES THE CONNECTOR
BACKPLANE.
1. Replace the blank cover plates on the rear of the intended slot in
the NV1000 frame with the backplane assembly for the NV1023
distribution amplifier. The FR1000 frame is supplied with a 2.5 mm
Allen wrench for this purpose. Ensure proper alignment of the active
module to the backplane with the following procedure:
a. Install the EM0104 backplane with the screws loose.
b. Plug the active module into the loose backplane.
c. With the active module inserted, tighten the screws securing the
backplane.
d. Remove the module and reinsert it to make sure it is properly
aligned with the backplane and the card guides in the frame. If
the alignment is not good, repeat the above procedure. When a
satisfactory fit is obtained, remove the module and continue
with the installation.
2. Make cable connections to the rear panel per the drawings included
in the Applications section (See Section 1.2).
3. Set the input termination jumper on the active module as required
by the application. Refer to Table 2 - NV1023 Jumper Setting and
the Component Location drawing in Section 6 for information on
the jumper location and setting.
4. Apply AC line power to the frame and insert the PS2001 power
supply if it is not already in place.
5. Insert the active module with power applied to the frame.
