N V I D I A C o r p o r a t i o n
48
N V I D I A D i s p l a y P r o p e r t i e s R e l e a s e 4 0
U s e r ’ s G u i d e
10
Click
nView Display Mode
to display the associated properties panel.
Notice that the nView Span/Clone mode options are disabled because you are
in nView Dualview mode. (
Figure 5.15
nView Span/Clone Options
Disabled
in Dualview Mode: Windows XP
Activating nView Dualview Mode: Windows 9
x
When you start Windows 9
x
in multi-display configuration, Windows starts in
“Dualview” mode. You may only need to do an “attach” procedure to enable the
secondary display device. Follow these steps
Notes:
• Dualview mode is not supported under Windows 95.
• Under Dualview mode, when you switch to a full-screen
Microsoft DOS window or boot to a DOS prompt, the display is
limited to the primary display device.
• Under Dualview mode, OpenGL-based applications will only
run using Microsoft’s software rendering implementation of
OpenGL. This is due to a design limitation within Windows.
.
nViewGuide_.book Page 48 Monday, August 11, 2003 4:03 PM
