1.
2.
3.
1.
2.
3.
1.
2.
1.
2.
It is strongly recommended to use an ESD strap or other antistatic devices.
Unpacking the Package
Check against the package contents list that all the parts have been sent. Check the parts for visible damage that may have occurred during shipping.
Please note that the cards must be placed on an antistatic surface.
Pre-Installation Checklist
Verify that your system meets the hardware and software requirements stated above.
Shut down your system if active.
Turn off the power to the system, and disconnect the power cord. Refer to the system documentation for instructions. Before you install the
BlueField BF1500 Controller Card, make sure that the system is disconnected from power.
(Optional) Check the mounting bracket on the BlueField BF1500 Controller Card.
If required for your system, replace the full-height mounting bracket that is shipped mounted on the card with the supplied low-profile bracket.
Refer to
.
Bracket Replacement Instructions
Bracket Replacement Instructions
The BF1500 Controller Card is usually shipped with an assembled high-profile bracket. If this form factor is suitable for your requirements, you can skip the
remainder of this section and move to
. If you need to replace the high-profile bracket with the short bracket that is included in the
Installation Instructions
shipping box, please follow the instructions in this section.
To replace the bracket you will need the following parts:
The new brackets of the proper height
The 2 screws saved from the removal of the bracket
Removing the Existing Bracket
Using a torque driver, remove the two screws holding the bracket in place.
Separate the bracket from the BF1500 Controller Card.
Save the two screws.
Installing the New Bracket
Place the bracket onto the card until the screw holes line up.
Screw on the bracket using the screws saved from the bracket removal procedure above.
Installation Instructions
This section provides detailed instructions on how to install your BF1500 Controller Card in a system.
Open the system case.
Place the BF1500 Controller Card in an available PCI Express slot.
Due to risk of damaging the EMI gasket, it is not recommended to replace the bracket more than three times.
Be careful not to put stress on BF1500 Controller Card LEDs.
Do not force the bracket onto the BF1500 Controller Card.
Use a torque driver to apply up to 2 lbs-in torque on the screws.
Please note that the following figures are for illustration purposes only.
The BlueField BF1500 Controller Card should be installed in a high power PCI Express x8 slot as the card consumes up to 55W.
