• Unwind heating element, cut and remove as shown.
• Lightly score clear jacket around and down as shown.
• Bend heating cable to break jacket at the score then peel off jacket.
• Remove 3/8 in. (9 mm) insulation from bus wires.
6 1/2 in.
(165 mm)
3/8 in.
(9 mm)
9C
5/8 in.
(15 mm)
10
• Mark both sides of jacket 5/8 in. (15 mm) as shown.
For VPL-CT go to Step 11. For all other heating cables
go to Step 12.
1 1/2 in.
(38 mm)
11
• Cut off and discard end of core sealer legs.
For VPL-CY only
Tubes
12
13
For VPL-CT heating cables
• Refer to material safety data sheet RAY5510.
• If needed, retwist and straighten bus wires.
• Insert bus wires into guide tubes as shown.
• Make sure all strands go into tubes.
• Push core sealer onto the heating cable to
the mark made in Step 10.
• Note: Extra force may be required for
larger cables.
nVent.com
|
6
