nux NMP-2, Owner'S Manual, Page: 6 / 13

foot switch is pressed. When foot switch A is set to the momentary type function(open or close), this
indicator lights only while the foot switch is held down.
4. Foot Switch B Indicator
When foot switch B is set to the latch type function, this indicator alternately lights or goes out each time the
foot switch is pressed. When foot switch B is set to the momentary type function(open or close), this indicator
lights only while the foot switch is held down.
5. DC Jack
The NMP-2 uses 9V (Positive outside, Negative inside) 2.5mm plug to active Latch mode, open mode(also
close mode with indicator).
6. Jack A
Connect the device being controlled with foot switch A here. Use a connection cable with 1/4” (6.35mm)
phone plugs at both ends.
7. Jack B&A
Connect devices equipped with TRS or TS 1/4” (6.35mm) phone jacks here. Use a connection cable with stereo
or mono 1/4” (6.35mm) phone plugs at both ends.
TIP
RING
SLEEVE
TIP
RING
SLEEVE
TIP
SLEEVE
TIP
SLEEVE
*TS(mono) is for foot switch B only. If you want to operate foot switch A and foot switch B at the same time,
you must use TRS(stereo) phone plugs here.
8. Mode Switch
This sets the functions for foot switch A and B to LATCH or Momentary( Open , Close).
*After referring the owner’s manual for the device you are connecting, switch this to the appropriate setting.
Open mode means while you hold the foot switch, the Tip and Sleeve is opened.(using mono cable)
Close mode means while you hold the foot switch, the Tip and Sleeve is closed.(using mono cable)
Product Description
Product Description