HILNA LS-C026
User Manual
Rev –
6
3.3
CONNECTIONS
Caution: Do not apply RF to the unit until after all cable connections are made and power has been
applied.
Making the connections from the
HILNA LS-C026
is easily accomplished:
1.
Connect the "RF OUT" connector on the unit to a 50
Ω
coaxial cable
2. Connect the RF Source to the RF In Connector with a second 50 Ω coaxial cable.
3. Connect the positive side of the power supply to the power pin and ground to the negative side
of the power supply. Power is now ready to be applied to the unit.
4.
Apply power to the unit
.
5.
Apply RF to the input cable assembly.
Powering down the unit is done by reversing this procedure.
Connection Summary:
•
Connect the RF Output to a good load. The characteristic impedance is 50 Ω.
•
Apply DC (+
6
VDC Typical) at the power connector
.
•
Connect an RF source to the RF Input connector.
Caution: Excess drive levels at the input to the amplifier can permanently damage
the unit. Under no circumstance should the RF Input level 20 dBm.
3.4
ENVIRONMENTAL SPECIFICATIONS
The
HILNA LS-C026
units
ar
e hermetically sealed
.
