Nuvoton NuMicro M483 Series, User Manual

Page: 29 / 40

NuMaker-M483KG
May. 10, 2019 Page 29 of 40 Rev 1.00
N
UMA
K
E
R
-M4
83
K
G
US
E
R MA
NUA
L
Ma
k
er Nu
-m
be
d
NUC
47
2
Us
er Man
ua
l
Find the Example Project 3.5
Use the “Template” project as an example. The project can be found under the BSP folder as shown
in Figure 3-7.

M480_Series_BSP_CMSIS_V3.XX.XXX

SampleCode

Template

GCC

Keil

IAR
Figure 3-7 Template Project Folder Path
Execute the Project under Toolchains 3.6
Open and execute the project under the toolchain. The section 3.6.1, 0, and 3.6.3 describe the steps
of executing project in Keil MDK, IAR EWARM and NuEclipse, respectively.
3.6.1 Keil MDK
This section provides steps to beginners on how to run a project by using Keil MDK.
1. Double click the
“Template.uvproj” to open the project.
Note: If Figure 3-8 warning message jumps out, please migrate to version 5 formats as shown in
Figure 3-9. The
“.uvproj” filename extension will change to “.uvprojx”.
Figure 3-8 Warning Message of
“Device not found”
‘M483KGCAE2A’