5
+
–
+ –
Fig. 8
Fig. 9
STEP 4:
Connect the subwoofer(s) to the amplifier using either option a or option b:
a.
Use the SUB terminal connections (for NV-SUBAMP200-xx and NV-SUBAMP500 models) See Figure 8:
1. Strip 1/4 in. (6.4 mm) of the cable jacket on each end of two cables.
2. Loosen the RED SUB 1 screw terminal on the amplifier.
3. Insert one end of a cable securely around the screw terminal.
4. Retighten the RED SUB 1 screw terminal.
5. Repeat steps 2–4 for the BLACK SUB screw terminal.
6. For dual subwoofer connection, repeat steps 1–5, for the SUB 2 side of the SUB screw terminals.
NOTE:
Expanding beyond the connection of one subwoofer will affect impedance. Make sure that the total impedance of SUB 1 & SUB 2 is a minimum of 4 Ω.
~or~
b.
Use a high-level in connection (for NV-SUBAMP100-xx models) See Figure 9:
1. Strip approximately 1/4 n. (6.4 mm) of insulation from the inner conductor wire.
2. Terminate the speaker wire into the modular plug
3. Insert the plug into the appropriate zone output on the back panel.
IMPORTANT:
Be careful not to let the exposed speaker wires touch. This will short the connection and could damage the amplifier
STEP 5:
Plug the power cable into the power cord inlet on the back of the amplifier.
