18
Network Camera User Manual
Then select the alarm holding time and set the alarm trigger options.
Alarm Out:
If selected, this would trigger an external relay output that is connected to the
camera on detecting a motion based alarm (
this function is only available for the model
with
alarm output connector
).
Trigger Snap:
If selected, the system will capture images on motion detection and save the
images on an SD card.
Trigger SD Recording:
If selected, video will be recorded on an SD card on motion
detection.
Trigger Email
: If “Trigger Email” and “Attach Picture” are checked (email address must be
set first in the Email configuration interface), the captured pictures and triggered event will be
sent into those addresses.
Trigger FTP
: If “Trigger FTP” and “Attach Picture” are checked, the captured pictures will
be sent into FTP server address. Please refer to FTP configuration chapter for more details.
2. Set motion detection area and sensitivity. Click the “Area and Sensitivity” tab to go to the
interface as shown below.
Move the “Sensitivity” scroll bar to set the sensitivity. Higher sensitivity value means that
motion will be triggered more easily.
Select “Add” and click “Draw”. Drag the mouse to draw the motion detection area;
Select “Erase” and drag the mouse to clear motion detection area.
After that, click “Save” to save the settings.