0
3.5 Programming the Setup Functions
3.5.3 Panning Range (Continued)
>> To program the ‘Panning Range,’ please follow the instructions below.
1. Press the [Scan] button to display the PTZ Scan menu. ([Menu] Button
_
Setup
_
Panning Range)
2. At ‘RIGHT LIMIT,’ while pressing down the [Shift] button, aim the camera to desired
right pan limit. Once the camera is pointed to the desired location, release the [Shift]
button.
Alternatively, you may initiate the view selection by twisting the Joystick handle. When
prompted, aim the camera to the desired location, then press the [Near] or the [Far] but-
ton to designate the ‘RIGHT LIMIT.’
3. Repeat the same method described above, designate the ‘LEFT LIMT’ position.
4. Move the cursor down to the ‘ENABLE’ option, enable or disable this function.
5. Move the cursor down to the ‘SWAP’ option. You can swap the ‘RiGHT LIMIT’ position
with the ‘LEFT LIMIT’ position using this option.
6. Finish the programming by scrolling down to the bottom to ‘SAVE AND EXIT.’
Note:
You must ‘SAVE AND EXIT’ to finalize the programming, pressing [ESC] button while
programming will exit programming without saving.
PAN RANGE SETUP
RIGHT LIMIT : 000.0
LEFT LIMIT : 007.2 (007.2)
ENABLE : ON / OFF
SWAP RIGHT/LEFT
SAVE AND EXIT
