Intelligent Surveillance Solution
page -11
Hardware Installation
Step1:
Insert the card onto an empty PCI-e slot. Connect the
BNC Cable
(not in product content) to the connector.
Note:
You need to power down the PC before you insert the card.
Step 2:
Connect the
Watchdog wire
to the
reset
connector on the main
board.
Note:
With the
Watchdog Wire
connected, the system will be restarted if
any abnormal conditions.
Step 3:
Turn on your PC and start Windows.
Step 3:
Insert the included Software CD into CD-ROM.
Step 4:
Refer the section Driver Installation on page 18 to install driver.
Step 5:
After driver is installed, restart your PC.
Optional I/O Card:
refer to the figures on the following pages.
Step 1:
Fix the IO card onto your PC.
Step 2:
Connect the Capture Card and the I/O Card with an included
ribbon cable (
2.00mm
IDC cable).
Note 1:
The default configuration of blue slide switch on I/O Card as
below.
Note 2:
If you only use one I/O card to connect with an 8004HD card,
please make sure the configuration of the black slide switch as below.
Maximum optional I/O Card support:
Maximum I/O Cards support for 6000S/7000S
