AMAZON
ASSEMBLY AND OPERATING INSTRUCTIONS
Place the nutrient tank in position ensuring
that it is level. Fill with water to the maximum
level indicator. Place the chamber in position
with the lowest drain point at the farthest end
from the tank access.
The Amazon delivery assembly will be packed
fl at. Turn the side arms at the blue elbow joints
so the sprinklers point up. Turn the centre bar
so the pump connector points down. The
arrows on the sprinklers should also be
pointing straight up.
Fit the strainer and foam fi lter to the pump
inlet. Make sure the pump outlet is at 90
degrees to the main body of the pump. Move
the foot and sucker to the bottom of the pump
so the pump outlet is upright.
Place the delivery assembly in position with
the side arms resting on the raised grooves in
the chamber base and the pump connector
through the hole in the nutrient tank.
Fit the pump outlet to the connector on the
delivery assembly. It is a tight fi t and may
require a little force. Put the pump into
position securing to the bottom of the tank
with the rubber sucker.
Place the lid in position (the picture shows the
16 space option). Then plug the pump in to
test, looking through several holes to ensure
that all 4 sprinklers are functioning correctly.
Put the correx tank cover in place to exclude
light from the nutrient solution.
Carefully place your young plants in the holes
(they should already be in net pots). If they
have dangling roots (i.e. have been raised
in an aeroponic propagator) turn them while
inserting, this will guide the roots through
without damaging them.
Add a fully balanced hydroponic nutrient
according to the nutrient label instructions or
growing schedule. Turn on the pump and top
up your nutrient tank every few days.
1
2
3
4
5
6
7
8
