Everyone hates cleaning up, which is just one more reason the NutriBullet is
such a wonderful time saver.
WARNING:
• ALWAYS UNPLUG THE NUTRIBULLET WHEN CLEANING OR ASSEMBLING.
Cleaning the NutriBullet is so easy… simply place any of the pieces (except for
the power base and blades) on the top shelf of the dishwasher or hand wash
with warm soapy water and rinse.
WARNING:
DO NOT WASH THE BLADES IN THE DISHWASHER. THE NUTRIBULLET CUPS
CAN BE WASHED IN THE DISHWASHER BUT ONLY ON THE TOP RACK USING
THE NORMAL (NOT SANITIZE) CYCLE. THE NUTRIBULLET CUPS AND BLADES
SHOULD NOT BE IMMERSED IN BOILING WATER FOR ANY REASON AS THIS
WILL WARP THE PLASTIC AND DAMAGE THE GASKETS.
STUBBORN CLEANUP
If ingredients dry inside the NutriBullet, make your cleanup a snap by filling the cup
about 2/3 full with warm soapy water and screw on the Extractor Blade. Place the cup
assembly on the NutriBullet, power base for about 20-30 seconds. This will loosen the
stuck ingredients, and with a light scrub, you’ll be all done.
CLEANING THE NUTRIBULLET POWER BASE
For the most part the power base doesn’t really get dirty, but if you neglect to
twist the blade on to the cup tightly, liquids can leak out and get into the base
and activator buttons.
Here’s how to clean it up.
Step 1: The most important thing is to UNPLUG the power base before cleaning!
Step 2: Make sure the blade is not attached to the power base.
Step 3: Use a damp rag to wipe down the inside and outside of the Power Base.
• NEVER SUBMERGE THE POWER BASE IN WATER OR PLACE IT IN
THE DISHWASHER.
• Never put your hands or utensils near the moving blade and never use your
hands or utensils to press the activator buttons down while the power base
is plugged in.
SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
CLEANING
THE NUTRIBULLET
STAINLESS STEEL VESSEL WARNINGS:
• NEVER BLEND HOT LIQUIDS OR FOOD OR CARBONATED BEVERAGES.
• NEVER BLEND FOR MORE THAN ONE MINUTE AS CONTENTS CAN HEAT
AND ERUPT UNDER PRESSURE.
• DO NOT OPEN UNTIL BLADES STOP.
• DO NOT EXCEED THE MAX LINE WHEN FILLING THE CUPS WITH
INGREDIENTS. THE MAX LINE IS LOCATED INSIDE THE VESSEL.
PITCHER WARNINGS*:
*For use with NutriBullet MAX, U.S. version only.
• ALWAYS USE THE VENTED TWO-PIECE LID WHILE OPERATING THE
NUTRIBULLET WITH THE PITCHER.
• DO NOT EXCEED THE MAX LINE.
• ALWAYS ATTACH THE BLADE TO THE PITCHER AND HAND TIGHTEN TO
PREVENT LEAKAGE.
• DO NOT REMOVE LID DURING PROCESSING.
• DO NOT ADD INGREDIENTS DURING PROCESSING. WAIT UNTIL MOTOR
STOPS COMPLETELY, REMOVE THE PITCHER FROM THE POWER BASE
BEFORE REMOVING THE LID. AFTER THE PITCHER HAS BEEN REMOVED
FROM THE POWER BASE, THE LID MAY BE CAREFULLY REMOVED AND
ADDITIONAL INGREDIENTS ADDED.
• WAIT AT LEAST 2 MINUTES BETWEEN BLASTING CYCLES.
• KEEP HANDS AND UTENSILS AWAY FROM THE LID OPENING AND /OR
CUTTING BLADE WHILE CHOPPING OR BLENDING FOOD TO REDUCE THE
RISK OF SEVERE INJURY OR DAMAGE TO THE DEVICE. A SCRAPER MAY BE
USED BUT ONLY WHEN THE NUTRIBULLET IS NOT RUNNING AND PITCHER
HAS BEEN REMOVED FROM THE POWER BASE..
• BLADES ARE SHARP! HANDLE CAREFULLY. USE CARE WHILE HANDLING
THE BLADES NOT TO TOUCH THE BLADE EDGES TO AVOID INJURY.
• KEEP HANDS AWAY FROM BLADES. USE CARE WHEN HANDLING BLADES.
• USE CAUTION WHEN OPENING AND POURING FROM PITCHER.
TASK
Blending
Chopping
Grinding
Ice Crushing
ITEM
Smoothies, vegetables, fruits, nuts
Tomatoes, olives, salsa
Grain
Ice
TIME
1 minute
Remove cup
after 4-5 seconds
30 seconds or
20-30 seconds
Remove cup after
4-5 seconds
WEIGHT
9-81g
90g
700g
800g
108g
for NutriBullet Prime
for NutriBullet Max
6
NUTRIBULLET, LLC
