Page 4
MODEL QTNLEDB
SERVICE PARTS
99045485B
KEY NO.
PART NO.
DESCRIPTION
1
SQTHB1
HANGER BAR KIT
2
475
DUCT REDUCER 6” TO 4”
3
97018562
DUCT CONNECTOR - 6”
4
99111293
SPACER (2 REQ’D)
5
97016466
HOUSING
6
98010102
WIRING PLATE
7
99170245
SCREW, #8-18 X .375
8
97018552
WIRE PANEL/HARNESS ASSEMBLY
9
97020045
CONTROL ASSEMBLY
10
97020046
SERVICE ASSEMBLY, BLOWER
(INCLUDES KEY NO. 11)
11
99420665
THUMBSCREW, #8-18 X .375
12
99140199
GRILLE SPRING (2 REQ’D)
13
97018561
GRILLE ASSEMBLY
14
99271381
BULB, GU24, 18W FLUORESCENT (2 REQ’D)
15
99111532
RING
16
99111529
LENS
* Not shown assembled.
Order service parts by “Part No.” - not by “Key No.”
INSTALL GRILLE
5. Finish ceiling.
Install ceiling material. Cut out around housing.
7. Attach grille to
housing.
Squeeze grille springs
and insert them into tabs
on each side of housing.
9. Remove light
lens.
Carefully insert a small
flat-blade screwdriver
between grille and lens.
Pry lens out.
8. Push grille
against ceiling.
SERVICE NOTE
To remove Blower
Assembly: Unplug motor.
Remove thumbscrew (11)
from motor plate flange.
Find the single
TAB
on the
motor plate (located next
to the receptacle). Push
up near motor plate tab
while pushing out on side
of housing. Or insert a
straight-blade screwdriver
into slot in housing (next to
tab) and twist screwdriver.
10. Install light bulbs.
Purchase (2) 18W (max.),
type GU24 fluorescent
lamps with M.O.L.
(maximum overall length)
of 3.9” (100mm) as
illustrated below.
Insert lamps and bulb into
their sockets. Replace lens.
3.9" (100mm) M.O.L.
6. Plug in wiring.
Plug wiring into proper receptacles.
DIAGONAL LED PLATE OPTION
To rotate LED plate to
diagonal position:
1. Remove grille from ceiling and
unplug wiring from housing.
2. Remove lens.
3. Remove three (3) screws from
retention ring.
4. Remove LED plate and rotate
plate clockwise to diagonal
position.
5. Re-assemble grille assembly
and re-install to fan housing.
LENS
SCREWS
RETENTION
RING
LED
PLATE
GRILLE
