MODELS CFS52BS • CFS52PB • CFS52RB • CFS52WH
Page 3
INSTALL THE FAN
REMEMBER to turn off the power. Follow the steps below to hang
your fan properly.
1. Pass the 120-volt supply wires through the center hole in the ceiling
hanger bracket as shown in Fig. 5.
2. Secure the hanger bracket to the ceiling outlet box with the screws
and washers provided with your outlet box.
3. Remove the hanger pin, lock pin and set screws from the collar.
4. Route wires exiting from the top of the fan motor through canopy
and then through the ball/downrod. (Fig. 6)
5. Select either the short or long downrod (included with the fan) and
align the holes at the bottom of the downrod with the holes in the
collar on top of the motor housing. Carefully insert the hanger pin
through the holes in the collar and downrod. Be careful not to jam
the pin against the wiring inside the downrod. Insert the lock pin
through the hole near the end of the hanger pin until it snaps into
its locked position. (Fig. 6)
6. Tighten two set screws on top of the fan motor firmly.
7. Place the downrod ball into the hanger bracket socket. This will
allow you to make the electrical connections. (Fig. 7)
FIGURE 5
UL LISTED
ELECTRICAL
BOX
CEILING
HANGER
BRACKET
HOOK
WASHERS
MOUNTING
SCREWS
(SUPPLIED WITH
ELECTRICAL BOX)
120V WIRES
FIGURE 6
DOWNROD
CANOPY
CANOPY COVER
SET SCREWS
LOCK
PIN
HANGER
PIN
FIGURE 7
REGISTRATION
SLOT
cover and canopy