Operating Manual and Inspection Book
POWER LIFT HL 2.30 NT / HL 2.35 NT / HL 2.40 NT
20100016 OPI
- 8 -
Version 1.1
2 Lift master forms
2.1 Manufacturer
Otto Nußbaum GmbH & Co.KG
Korker Strasse 24
D-77694 Kehl-Bodersweier
2.2 Purpose
The lift is a lifting tool for raising vehicles with a total weight of (* see list) in normal workshop
operation at a maximum load distribution of (2:3**) (1:3***) in or against the drive-in direction A
single load from only one or two lifting arms may not happen.
Set up of the standard lift in explosion endangered workshops and humid spaces (e.g. washing
halls) is prohibited.
Lift operation is done directly on the operating column (see Data sheet).
After construction and maintenance changes on load carrying parts the lift must be inspected
afterwards by a specialist who approves the changes. If the set up location is changed, the lift must
be checked again by a specialist and changed approved.
(*)
Load carrying capacity of the POWER LIFT HL 2.xx NT series
POWER LIFT HL 2.30 NT**
= 3.000 kg
POWER LIFT HL 2.35 NT**
= 3.500 kg
POWER LIFT HL 2.40 NT ***
= 4.000 kg
* DT =
Double
telescope
lifting arms
(previously
MB arms)
Lifting arm
variants
Standard arm
Mini-Max arms
(MM)
DT*
Lifting arm
Sport Cars
lifting arm
(SC)
POWER LIFT
HL 2.30 NT
590-900 mm
940-1495 mm
560-1030 mm
1000-1545 mm
480-870 mm
940-1495 mm
_
POWER LIFT
HL 2.35 NT
505-823 mm
940-1495 mm
_
570-1160 mm
940-1495 mm
590-865 mm
840-1380 mm
POWER LIFT
HL 2.40 NT
570-1160 mm
1130-1840 mm
635-1065 mm
1130-1840 mm
_
_
Summary of Contents for HL 2.30 NT
Page 2: ......
Page 94: ...Notes ...
