Nussbaum ATT COMBI LIFT 4.40 S, Operating Manual, Page: 124 / 260

124 OPI_COMBI LIFT 4.40 S PLUS AMS - HYMAX II 4000 S PLUS AMS_V1.0_DE-EN
1 General information
Technical documentation contains important infor-
mation for safe operation and for retaining functio-
nal safety of the system.
• To verify system set up, the set up protocol form is
to be signed and sent to the manufacturer.
• Forms are available in this inspection book for use
in verifying single, regular and extraordinary safe-
ty checks. Use the forms to document inspections
and leave the completed forms in the inspection
book.
• The system master forms must record changes to
the construction and changes to set up location.
1.1 Set up and test the system
Safety relevant work on the system and safety in-
spections may only be done by personnel speci-
fically trained to carry it out. They are designated
in general and in this documentation as technical
experts and specialists.
• Technical experts are people (freelance expert
engineers, TÜV specialists) that may inspect and
assess due to their education and experience
with lift systems. They are knowledgeable in the
appropriate work safety and accident preventi-
on regulations.
• Specialists (competent people) are people who
have sufficient knowledge and experience with
lift systems and have participated in a special
factory training by the system manufacturer.
1.2 Hazard information
To become aware of the hazardous points and im-
portant information, the following three symbols are
used with the descriptive meaning. Pay particular
attention to text positions that are labeled by these
symbols.
i
Note! Labels information about a key function
or points to an important remark!
!
Caution! identifies a warning of possible system
damage or other operating company property
damage if the highlighted process is not done
properly!
Danger! Identifies a danger to life and
limb, if the highlighted process is not
done properly there is a mortal dan-
ger!