Nussbaum 2.35 TSK, Operating Instruction And Documentation

Page: 19 / 35

Operating Instruction and Documentation
2.35 TSK
- 19 -
• Press the button „ Lifting“.
• Check the safety device of the lifting arms. They must lock if the arms leave the floor.
• If the wheels are free, stop the lifting procedure and check again the safety position of the
vehicle.
• Lift the vehicle on the working height. Observe the complete process.
Pic 1: operating unit with internal hydraulic unit.
5.2 Lowering the vehicle
• Check the dangerous places of the lift and be sure that there are no objects or people in
the immediate area of the lift or on the lift.
• Press the button „lowering“.
• Observe the complete process.
• If the lift is in the lowest position, turn the carrying arms to the outside.
• Drive the vehicle out of the lift.
6.Troubleshooting
If the lift does not work properly, the reason for this might be quite simple. Please check
the lift for the potential reasons mentioned on the following pages. If the cause of
trouble cannot be found, please call the technical service.
Problem: Motor does not start!
Potential causes:
No power supply
Main switch is not engaged
The main switch is defective
Fuse defective
The feed line is cut
Thermal switch in the motor is active
Motor is defective
solution:
Check the power supply
Check the main switch
Check the main switch
Check Fuse
Check the complete cable
Let motor cool down
Call technical service