10
T 01460 68600
Machine Operation
The brush load lever is located to the right hand side of the machine.
This option is for hard to clean patches, adding extra pressure to the brushes.
NOTE: It is recommended this option is NOT used all the time and is for spot cleaning only.
The run-time of the machine may decrease if the load on the brushes is increased.
Brush Pressure / Load Adjustment
To operate, set water flow rate tap, lower brush deck, lower the floor tool, press the vacuum / water switches, pull brush On/Off trigger.
The waste water is then retrieved by the suction floor tool.
Overlap each scrubbing path by 10cm to ensure an even clean.
Do not operate the machine on inclines that exceed (2%), (9%) for Traction machines, when full.
On heavily soiled floors use a ‘double scrub’ technique.
First pre-scrub the floor with the floor tool in the raised position, allow the chemical time to work then scrub the area a second time
with the floor tool lowered.
If streaking occurs wipe floor tool blades clean.
NOTE: Care must be taken to reduce speed when cornering or when manoeuvring around obstacles
The floor tool design incorporates a
break-away feature.
Allowing it to safely disengage from its
mounting should it become caught on
an obstruction, during forward machine
movement.
To re-attach the blade to its holder. First
loosen the retaining knobs on the floor tool
body and slide onto the holding bracket.
Tighten retaining knobs to finger tight.
Break-away Floor Tool
Machine In Use
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.
!
!
(A)
Standard Duty
24 Kg Pressure
(B)
Heavy Duty
32 Kg Pressure
A
B
Summary of Contents for TGB 6055/100
Page 24: ...24 T 01460 68600 EU Declaration of Conformity...
Page 25: ...25 T 01460 68600 Warranty...
Page 26: ...26 T 01460 68600 Notes...
Page 27: ...27 T 01460 68600 Notes...
