PA5Pro
PA5PRO REAR PANEL DIAGRAM AND FEATURES
...
3
2
6
5
9
8
4
10
7
1
11
12
1. GND is the grounding lug for turntables 1, 2 and 3
(phono inputs on Channels 1, 2 and 3). Always use
this connection (your turntable cable should have a
grounding wire).
2. The Automute Switch should be set to the on
position if you want inputs 3-6 to lower volume
automatically when the microphones are spoken
through. Set it to the off position if you don’t want
the inputs affected.
3. Phono Inputs use unbalanced RCA jacks. Your
input signal is fed directly to the P A 5 P R O's high-
quality RIAA phono pre-amplifiers so use this
position only for moving magnet cartridges. Line
level sources will overload the sensitive phono pre-
amps and will sound very bad, so always be sure to
toggle the line/phono switch over to line before
connection of line sources.
4,5,6. CD,Tape, and Aux Line Inputs are
unbalanced RCA jacks. You can connect stereo
audio from HiFi VCRs, cassette and reel-to-reel tape
decks, DAT machines, CD players, laser discs,
tuners, even synthesizers or other mixing consoles.
N O T E :
Plug mono audio sources into both Left and
Right inputs using a “Y” cable connector.
7. The Tape Outputs are low-impedance
unbalanced RCA jacks which output the program
mix and allow you to connect any recording device.
8. The Stereo Main RCA Outputs are low-
impedance RCA connectors controlled by the
Master fader.
9. The Stereo Binding Post Outputs are low-
impedance hard-wire connectors controlled by the
Master fader
10. The Stereo XLR Balanced Outputs are
balanced low-impedance outputs for connecting to
other balanced amplifiers or devices. Use these
outputs whenever possible for the best sound.
11. AC Cord. See safety precautions on page 3 for
proper treatment of the power cord.
12. Voltage Selector should be set before you
plug the unit in to the correct voltage for your
location.
Numark - The Proven Leader in DJ Technology
©1997 Numark Industries
7
http://www.numark.com