Next, install Interlock Clips to secure frame to Awning: Connect Awning Slat
Section Assembly to the Center Rafter frame using Interlock Clips at each joint
where the slats interlock. Installing clips is a three-step process: (1) Find the slat
joints; (2) Insert the curved part of clip into slat joint; (3) Slide clip onto Center
Rafter. Interlock Clips are installed on the flat section of the awning only, not up
on the curve. If stubborn, make sure they are straight and parallel with the slat
joint.
Interlock
Clip
Align Camel Back Wall Brackets and secure them to the wall with large screws at
the correct mounting points. Make sure they are plumb and square.
Installation of awning with Support Arms is now complete.
Camel Back
Wall Bracket
Below: Detail
Install Mounting Bar and secure with large screws on the window frame or
in strong sheathing on the house around the window (if you measured for
placement of your awning on the
outside
of the window frame). In this case,
install the Mounting Bar on the house above the window frame.
Be sure the Mounting Bar is level and centered over the opening.
l
!
Caulk the top of the Mounting Bar against the house.
Caulk
Mounting Bar
SERIES 4100
Support Arms
Lift the front of the awning upward and insert the Top Trim into the
Mounting Bar (FIG. 2A). Lower the front of the awning slowly and
allow Support Arms to rest on the house (FIG. 2B); be sure the two
parts are completely interlocked. Align holes and secure Top Trim
to Mounting Bar with small screws from bottom side (FIG. 2C).
Temporarily attach the two loose Camel Back Wall Brackets to
the other end of the Support Arms using machine screws. Before
securing to your house, please refer to the mounting chart below
for model number and correct mounting points for your awning.
NOTE: Mounting dimension ‘A’ is measured from the top of the
Mounting Bar to the center of the Camel Back Wall Bracket.
Attach mounting brackets to the house using large screws
(provided), making sure the brackets are secured in solid sheathing
at the proper points from the reference chart.
Mounting Bar
Window
Frame
Aluminum Casement Window Awning Mounting Chart
Model Number
6
7
8
9
Mounting Point
18-1/2”
24”
29”
34-1/2”
All mounting points are approximate
Installation Instructions
7
1
2
3
FIG. 7
FIG. 1
Attach Camel Back Wall Brackets (all four) to Support Arm ends using machine
screws provided. The head end of the machine screw should be on the outside
of the awning when inserted into the bracket. Then, attach one end of the
Support Arm with bracket to the awning with small screws. Repeat this step for
the second Support Arm. The two opposite ends with Camel Back Wall Brackets
will be attached to the house with larger screws during installation.
Camel Back
Wall Bracket
Support Arm
8
FIG. 8
FIG. 3
(Front) - Canopy Frame Views - (Side)
Camel Back
Wall Brackets
A
A
Mounting Bar
Mount Camel Back
Wall Brackets
plumb and in line with
Mounting Bar
Mounting Bar
small screw
lower front
of awning
slowly
lift
awning
upward
insert
FIG. 2A
FIG. 2C
interlocked
FIG. 2B
support arm
camel
back
wall
bracket
