26
Run enough water into the tank to cover the bottom.
This will aid the breakup of solid wastes. The gray
water knife valve may be left open.
Keeping the black water tank clean allows the
monitor panel to accurately assess the status of the
tank. Always remember to clean up the dump site
before leaving. Never empty your holding tanks
directly on the ground or into a river or stream. DO
NOT pollute!
Holding Tank Care
Since holding tanks don’t rely on any sophisticated
mechanical devices for their operation, they are
virtually trouble-free. The most common problem is
also an unpleasant one, clogging. You can minimize
chances of clogging by keeping the following
considerations in mind:
•
Keep the black water tank knife valve
closed. Be sure to cover the tank bottom
with water after dumping.
•
Movement while driving will help liquefy
the solids.
•
Use only toilet tissue formulated for use in
septic tank or camper sanitation systems.
•
Keep both knife valves closed and locked,
and the drain cap tightly in place when using
the system on the road.
•
Use only cleaners that are approved for use
in septic tank or camper sanitation systems.
•
Use a special holding tank deodorant
chemical approved for septic tank systems in
the black and grey water holding tanks.
These chemicals aid the breakdown of waste
and make the system much more pleasant to
use.
•
Do not put facial tissue, paper, grease,
ethylene glycol-based or other automotive
antifreeze, sanitary napkins or household
toilet cleaners in the holding tanks.
•
Do not put anything solid in either tank that
could scratch or puncture the tank.
If the drain system does get clogged:
•
Use a hand-operated probe to loosen
stubborn accumulations.
•
Seriously clogged P-traps may require
disassembly. Be careful not to over tighten
when reassembling.
Do not use harsh household drain cleaners. Do not
use motorized drain augers.
Sometimes the holding tank valve will get clogged.
In this case, a hand-operated auger may be
necessary. Be ready to close the valve quickly once
the clog is cleared. If the seal gets damaged, it must
be replaced.
Water System Maintenance and Troubleshooting
As with any mechanical system, your plumbing is
subject to the development of problems. Most of
these problems can be greatly reduced, if not
eliminated, by following a schedule of planned
inspections and maintenance. Neglect of proper
maintenance procedures is the usual cause of most
water system problems.
Road vibrations and shocks, as well as excessive
pressure from some city water sources, are the main
physical causes of water system damage. It is
important to inspect all plumbing joints and fittings
often for cracks and leaks. If left unchecked, water
leaking from a plumbing joint can cause
considerable damage.
A leak in the fresh water system should be
suspected if the pump is running and all faucets and
valves are closed. When the leaking fitting has been
identified, attempt to stop the leak by tightening the
fitting. DO NOT over-tighten. Plastic fittings rarely
need to be tightened with a wrench. If these fittings
leak after tightening by hand, disconnect the fitting
and check for dirt, scale, or other foreign substances
which may be causing the leak. Clean the fitting
thoroughly and reinstall. If leaking persists, shut off
the water supply until the fitting can be properly
replaced. Check with your dealer for the correct
method of replacement and replacement parts.
Proper winterization procedures of plumbing
systems will normally be all that is necessary to
prevent the damage caused by freezing. Freezing
damage can harm any component of the system,
including the water tanks, toilet, pump, and all
piping. Be sure to follow the winterization
procedures outlined in this manual. Also, be sure to
discuss with your dealer or repair center any
additional precautions that should be taken to
winterize your camper’s plumbing system. Local