4
4
Aufstellhinweise
The RS-54 as a Dolby Atmos Enabled
Up-firing Speaker
Home cinema systems capable of decoding immersive audio
formats can take advantage of specially designed speakers to
“bounce” sound off the ceiling to create the illusion of sound coming
from above. In a room with a reflecting ceiling-surface, this works
very well. Ceiling height should be 2.2 – 3.7 m for optimum results.
In this case, the RS-54 is placed horizontally on top of your front- or
surround-speakers with the lowest edge towards the listener (see
below).
The RS-54 is designed to fit on a wide range of speakers, e.g.
– nuBox 513 or 683
– nuLine 34, 284 or 334
– nuVero 60, 110 or 140
When placed on your existing speakers, the speakers will in most
cases be in the correct position and add an extra dimension to your
surround sound system. It is also possible to place the speakers in
close proximity to your front- or surround speakers, e.g. on a shelf.
To set up your surround system optimally, we recommend reading
the recommendations from Dolby at www.dolby.com or contact our
service-hotline experts at:+49 7171 8712-0
■
Switch settings
Set the switch (located between the two binding posts) to
Refle-
ktierend (reflecting)
. With the switch in this position, the RS-54
complies fully with Dolbys requirements for reflecting speakers and
is a fully Dolby-tested and licensed Dolby Atmos
®
enabled speaker.
■
Bumpers
We recommend using the small bumpers to ensure the best pos-
sible stability.
The RS-54 as an Effect-speaker,
e.g. in the Front- or Rear Height Position
Due to the 20 degree angled front, the RS-54 is perfectly suited
for surround channels that are placed above the hearing position,
Front- or Rear Height channels for instance.
In this role, the speakers are hung on the wall as shown below. The
speaker cables are unobtrusively connected to what is now the top
of the speaker.
■
Switch Settings
Set the switch (located between the two binding posts) to
Direkt.
■
Bumpers
Depending on how far away from the wall you want or need the
speaker to be, you can use the large or the small bumpers.
■
Wall-mounting
Always use the appropriate screws and dowels for the kind of wall
you want to mount the speakers on.
Make sure the speakers are mounted securely and can’t fall down.
In order to mount a speaker, you must drill two level holes, 90mm
apart horizontally. Please note that you need to leave a few millim-
eters of space above the speaker in order for the screws to fit into
the keyholes on the speaker.
Note the template on page 7!
Setup and Placement
nuLine RS-54
· 09/2020 EN