Adjusting the Temperature Set Point
The occupier will normally require the heater to activate when
the loft temperature falls below a predetermined point.
We recommend that the temperature set point be set at 10
o
C.
Electrical Connection
The heater is rated at 500 watts and should be connected to
a suitably rated power supply via a switched fused spur
(by others).
Remove the cover and connect mains to L/N/E as shown in
figure 4.
Communication Connection
a) Drimaster
link
-
should be fitted at J5. Figure 4.
b) For Drimaster 2000 and Drimaster 365 -
wire sensor
cable to terminal J3 on heater. See figure 5.
c) Dri-Ecosmart and Sunwarm -
connect heater net
connector to any of the four net connections on the main
unit control. See figure 4.
Maintenance
The unit does not require any maintenance. However, for
optimum performance, it is advisable to remove any
accumulated dust with a low power vacuum cleaner.
NOTE: Installation and Maintenance of the equipment must
be as directed in the instructions provided with the unit.
Warranty
The 3 year warranty starts from the day of delivery and
includes parts and labour for the first year.
The remaining 2 years covers replacement parts only.
This warranty is conditional on planned maintenance
being undertaken.
Service Enquiries
Nuaire can assist you in all aspects of service. Our service
department will be happy to provide any assistance required,
initially by telephone and If necessary arrange for an engineer
to call.
Telephone 029 2085 8585
Fax 029 2085 8586
Installation and Maintenance
ECO Dri Heater
Technical or commercial considerations may, from time to time, make it necessary to alter the design, performance and
dimensions of equipment and the right is reserved to make such changes without prior notice.
To Drimaster
2000 and
Drimaster 365
Figure 4.
Figure 5.
2
Leaflet Number 671195 February 2011
Ensure the fan is running before operating the heater.
If the heater should trip out the power should be isolated for
several minutes to allow the unit to reset the thermal trip.