-9-
-2-
G.Pa ir ing the tr a ns m itte r a nd re c e iv e r
When you get the transmitter/digital wireless cameras or receiver, you must pair
them before use it, following the instructions as below:
1.Power on the transmitter and receiver by inserting the power adaptor jack.
2.Press the pair button of transmitter or receiver and not release until the power
LED begin to flash, then release the pair button.
3.
They will enter into the pairing state and automatically link to each other
by ID code after step 2 finished.
4.
Please don't turn off their power switch during the paring status.
5.
When pairing successfully, the power LED for both will be lit directly (not
flash)
.Wha t is ins ide the B ox ?
Please check the following items inside the box for 2.4Ghz Digital Wireless
camera, or Digital AV sender with IR extender (option), and contact your dealer
if anything is missing:
1. Products body
and
Receiver x 1
Transmitter x 1
Please note:
Pairing Button
or
2. Accessory: for receiver and transmitter
2-1.Refer to the following photo, from left to right:
2-2.Antennas x 2 for Transmitter and Receiver
2-3.AV cables x 2(3RCA plug to 3RCA plug)
2-4.Power Adaptor x 2(100V ~ 240V AC,
DC 12V/1A in Jack)
2-5.Optional IR extender x 2 for Transmitter
(orange color) and Receiver (black color)
Pressing the pairing buttons for transmitter and receiver is not necessary at the
same time, and they are not necessarily put near or side by side in pairing status,
around within 3 meters far is OK. Under the transmission, you can see the strength
signal on the monitor (RX) as below, and will disappear after 5 seconds; press RX
pairing button will make it shown again:
3. Accessory for digital wireless camera
3-1.Refer to the following photo, from left to right:
3-2.Antennas x 1
3-3.Power Adaptor x 1(100V ~ 240V AC,
DC 12V/1A in Jack)
3-4.Bracket with screws x 3
4. This user manual
Optional
