TFTN 085-199 Installation and Operation Manual
99
16.4 Zone Details
Figure 16-20 Zone Details Screen
Central Heating:
Lists the details and status of each of the CH zones. Note: Zone
# 4-6 correspond to zones 1-3 of a second zone controller
(applicable for cascade system or with N-link 3ZC).
Room Temp
–
current room temperature (only applicable for
zones using NTI Room Sensor)
Active
–
status of the zone input; turns green when the zone is
calling, and the Priority Level is current
Boiler Target
–
calculated (Current) boiler target temperature
and possible range (Min/Max) dictated by the given zone.
Adjustable via the
menu
Output
–
status of the zone output; turns green when the
output is switched on
AUTO Temp Contrl Mode
–
adjustable via
Priority Level
–
adjustable via
-> Advanced Settings
DHW:
Lists the details and status of the DHW Demands, IWH (Tank Sensor
or Aquastat / Downstream or Upstream) and Recirc.
Setpoint
–
adjustable via
Temperature
–
current temperature readings from
DHW
SWITCH/NTC
and
AUX2 NTC
Active
–
status of the demand; turns green when calling
Boiler Target
–
boiler target temperature dictated by the given
zone. Adjustable via
Modulation Setpoint. Not applicable for DHW Recirc.
Output
–
status of the DHW and DHW Recirc pumps.
16.5 Boiler Details
Figure 16-21 Boiler Details Screen
Target
–
select to have the
system walk you through a
step-by-step setup
procedure of the controller
BMS
–
only applicable
when BMS Control Mode is
set to 0-10V (Power/Temp)
Inputs
–
gives the status of
each of the boiler’s on/off
inputs
System
–
only visible when
a sensor is connected to
AUX1 NTC
and Auxiliary
Sensor 1 is set to System
Sensor
Outlet 1,2
–
readings from
the boiler’s duplex outlet
sensor
Outputs
–
gives the status
of each of the boiler’s
on/off outputs, green
means on
