UME-TVW01-05/16
www.newtableconcept.com
Page 8
under the
springs cover
(Fig. 25).
12 Screw the three lower screws of the
mounting plate
without tightening them.
Pay attention not to
scratch the frame
.
13 Place a piece of foam of the packaging in the middle of the
spring cover
(Fig. 26). The piece of
foam will protect the
spring cover
against scratches during the t
able top
assembly.
Fig. 24
Fig. 25
Fig. 26
14 Lift the
spring cover
and place one of the two wooden spacer (removed a little earlier) between the
table frame
and the
springs cover
(Fig. 27).
15 Close slowly the
table frame
. It will remain about 15 degrees open due to the presence of the
wooden spacer and the piece of foam (Fig. 28). This will allow the assembly of the
table top
.
Fig. 27
Fig. 28
16 Slide carefully the
table top
inside the
table frame
and make sure the
table top
will fully slide inside
the
table frame
(Fig. 29).
17 Screw the
table top
to the
table frame
using the two M6 conical head screws (Fig. 30).
Fig. 29
Fig. 30
