Metal detector
GB
Metal detector
GB
a.
DISC
—Rotate the control clockwise away from ALL METAL to get DISC mode. The DISC mode
comes with auto ground balance. Rotate the control slowly and clockwise to eliminate different
trash objects. Rotate the control counter clockwise to the end to get ALL METAL mode. All METAL
also comes with auto ground balance. It’s used to find not only ferrous metal, but also non-ferrous
one (see more details below).
b.
SENS
—Rotate the control counter clockwise to the end to power off the unit.
Rotate the control clockwise to power on the unit. Continue rotating it clockwise to get higher
sensitivity.
c.
VOLUME
—Rotate the control clockwise to get higher level or to get lower volume level by
rotating it counter clockwise.
d.
LOW BAT
—Low battery indicator. When LOW BAT indicator lights, user should replace the
batteries at once.
f.
EAR
—It’s a 3.5mm headphone jack for connecting headphones.
g. View meter—When unit finds any metal target , the meter pointer swings to the right.
h.
PINPOINT
—Lets you find the location of the target being detected accurately. In ALL METAL
mode, when you find metal object, you can press to pinpoint the target. Hold the search coil 50 cm
or more away from the ground. Press and hold down this button. Sweep the search coil over
the sound area and release the button when you hear a sound. After about 1~2 seconds, hold
down the red button again, the sound disappears. Closer the search coil to the ground and you’ll
hear the sound again. Repeat the above steps until you find the target. After you find the target,
set mode to DISC to determine which kind of metal the target is.
TESTING AND USING THE DECTECTOR
The model GC-1039 metal detector has three operation modes: ALL METAL, DISC and
PINPOINT. ALL METAL is used to find all kinds of metal targets. DISC is used to discriminate the
metal type. PINPOINT is used to locate the target accurately.
In general case, user firstly sets the operation mode to ALL METAL, DISC to counter clockwise
end, SENS to high position. Then hold the search coil parallel with the ground about 1~5 cm
above the surface. Sweep the search coil from side to side in an arc line of 7cm motion.
When the detector detects a buried target, it sounds a tone. User can make a visual note of exact
spot on the ground where the detector beeps.
Then stop the search coil directly over this point on the ground. Move the search coil straight
forward away from you and straight back towards you a couple of times.
In ALL METAL mode, when you find metal object, you can also press PINPOINT to locate the
target. Hold the search coil 50cm or more away from the ground. Press and hold down this button.
Sweep the search coil over the sound area and release the button when you hear a sound. After
about 1~2 seconds, hold down the red button again, the sound disappears. Closer the search coil
to the ground and you’ll hear the sound again. Repeat the above
Summary of Contents for 5705858717234
Page 34: ...Metal detector...