NSFOCUS ADS M Installation Guide
Copyright © NSFOCUS
15
V4.5R90F02 (2020-02-28)
Terminal software that can connect to the console port (for example, the HyperTerminal
software that comes with the Windows operating system)
ADS M (hardware) connected to the computer with the serial cable
Here, the HyperTerminal software is used as an example to detail the connection process:
Step 1
Use terminal software to connect to the console via the console port.
For parameter settings of the console port, see appendix
Step 2
Type the user name and password of the console administrator.
If the user name and password are correct, you can successfully log in to the console.
----End
Note that you can only operate on the keyboard on the console. Type a sequence number
as prompted and press
Enter
to open the console management menu.
4.2
Network Configuration on the Console
After you successfully log in to the console of ADS M, the main menu is displayed, as shown
in
. Type a sequence number as prompted and press
Enter
to open a menu.
Figure 4-1
Main menu of the console
Perform the following steps to configure network parameters as required:
Step 1
On the main menu, type
5
to open the
Console password
menu.
Step 2
Type the new password, which must be at least 6 bits long. Then type
y
and press
Enter
to
make the setting take effect.
