4
IV. Information for Use with a Self-
Contained LP-Gas Supply System
DO NOT STORE A SPARE LP GAS CYLINDER UNDER OR
NEAR THIS APPLIANCE.
NEVER FILL THE CYLINDER BEYOND 80% FULL. IF
THESE TWO STATEMENTS ARE NOT FOLLOWED
EXACTLY, A FIRE CAUSING DEATH OR SERIOUS
INJURY MAY OCCUR.
• If your oven is factory-built for LP (Propane)
the regulator supplied is set for 11" W.C. and is
for use with LP gas only. The factory-supplied
regulator and hose must be used with a 20 LB LP
cylinder.
• The LP-gas supply cylinder must be constructed
and marked in accordance with the
Specifications
for LP-gas Cylinders
of the U.S. Department of
Transportation (D.O.T.) or the National Standards
of Canada
CAN/CSA-B339, Cylinders, Spheres
and Tubes for the Transportation of Dangerous
Goods, and Commission,
as applicable; and
1. Provided with a listed overfilling prevention
device
2. Provided with a cylinder connection device
compatible with the connection for outdoor
cooking appliances
3. Marked with a 20 LB LPG capacity
It must be provided with a shut-off valve terminating
in gas tank valve outlet. It must include a collar
to protect the cylinder valve. The cylinder supply
system must be arranged for vapor withdrawal.
• Install the factory-supplied hose and regulator
assembly as shown in illustration. Connect the
3/8" flare end of the hose to the oven piping
outlet coupling using a ¾" open wrench. Do not
apply pipe sealant to the ¾" flare connection.
Installation Continued
Locate and orient the LP cylinder to provide proper
vapor withdrawal. Connect the regulator to the
LP cylinder. Hand tighten it. Do not use a wrench.
Check for leaks using a soapy water solution.
NEVER USE OPEN FLAME TO CHECK FOR GAS
LEAK.
Note:
Any 20 LB LPG cylinder can be used provided it
is compatible with the retention means as shown in
photo.
• If the oven is not in use, the gas must be turned
“OFF” at the supply cylinder. The cylinder must be
disconnected from the oven and stored outdoors,
out of the reach of children and must not be stored
in building, garage or any other enclosed area.
• Always inspect the hose before each use of the
oven. If it is evident there is excessive abrasion or
wear, or the hose is cut, it must be replaced prior to
the oven being put in operation. The replacement
hose assembly shall be that specified by the
manufacturer.
The pressure regulator and hose assembly supplied
with to the oven must be used. Replacement of
pressure regulator and hose assembly must be those
specified by the oven manufacturer.