16”/40cm Pedestal fan
Thank you for purchasing this pedestal fan. Please read the instructions and warnings
carefully before use to ensure safe and satisfactory operation of this product. Please
retain for future reference.
Appliance components
Assembly
FIG 1
1. Assemble Base Plate
a. Loosen and remove base nut (20) from
pedestal (18).
b. Insert the pedestal into the base plate (19).
c. Secure the pedestal onto the base plate with
the base nut.
FIG 2
2. Assemble Pedestal
a. Release inner pole (16) from pedestal (18) by
loosening height adjustment bolt (17) &
retightening.
b. Insert the main fan body onto pedestal and
secure in place with controls housing bolt (15).
Assembly
(Cont’d)
FIG 3
3. Assemble rear grille
a. Remove and discard the plastic tube from the
motor shaft.
b. Remove the blade cap (5) by turning clockwise
and the clamping nut (7) by turning anticlockwise.
c. Install the rear grille (8) by positioning onto the
three pins on the front motor cover (10).
d. Lock and secure the rear grille with the clamping
nut (7) by turning clockwise.
FIG 4
4. Assemble fan blade
a. Insert the fan blade (6) onto the motor shaft (9)
and adjust, as necessary, onto the pin.
b. Fit the blade cap (5) onto the motor shaft and fix it
lightly by turning anticlockwise, as illustrated.
c. Make sure the fan blade moves freely and does
not catch on the rear grille or clamping nut.
d. If the blade does not rotate freely, repeat steps 3
& 4 above.
FIG 5
5. Assemble front grille
a. Align the front and rear grilles correctly (1 & 8).
b. Position the top clip on the front grille with the top
part of the rear grille (see top inset image).
c. Loosen the safety screw (2) and open the locking
clip (3) at the bottom of the guard ring (4).
d. Press the guard ring firmly over the back grille, close
the locking clip and tighten the safety screw.
FIG 6
6. How to remove the front grille (for cleaning)
Reverse instructions on #5 & #4 above:
a. First loosen the safety screw & open locking clip.
b. Twist & separate the back grille from the guard ring,
then pull downwards to remove it.
c. Lift away the front grille from top clip mentioned in
5b above.
Operation
1.
Once the fan is assembled, plug into an electrical socket and switch on power.
2.
Choose the desired speed by twisting the speed control switch (14) to 1 = LOW,
2 = MED or 3 = HIGH and 0 = OFF.
3.
To make the fan oscillate, push down on the oscillation knob (12) located on the top
of the motor housing. To stop the fan from oscillating, pull up the oscillation knob.
Tilt adjustment
:
Gently tilt the fan head up or
down to the desired angle.
NB Only adjust tilt when the
fan is turned off
Height adjustment
:
Loosen the height adjustment
bolt (17), adjust the inner pole
to the desired height and
re-tighten bolt
2
3
1. Front Grille
11.
Carry Handle
2. Safety Screw
12.
Oscillation Knob
3. Locking Clip
13.
Angle of Tilt
4. Guard Ring
14.
Speed Control Switch
5. Blade Cap
15.
Controls Housing Bolt
6. Fan Blade
16.
Inner Pole
7. Clamping Nut
17.
Height Adjustment Bolt
8. Rear Grille
18.
Pedestal
9. Motor Shaft & Pin
19.
Base Plate
10. Motor Housing (Front)
20.
Base Nut