INTRODUCTION
Congratulations on the purchase of your Digital
Hygrometer & Thermometer.
Maintaining the correct temperature and
humidity levels is beneficial to us and our homes.
Room Humidity is best maintained between 45-
55%RH where the health risk from viruses, fungi
and dust mites are minimised.
If the Hygrometer/Thermometer displays a
reading of 45% or less this indicates that you
may need a humidifier to increase the moisture
content of the air.
If the Hygrometer/Thermometer displays a
reading of 55% or more this indicates that you
may need a dehumidifier to remove excess
moisture from the air.
IMPORTANT SAFETY INSTRUCTIONS
When using any electrically powered product,
basic safety precautions should always be
followed.
PLEASE READ ALL INSTRUCTIONS CAREFULLY
BEFORE USING THE PRODUCT.
♦
This thermometer is not a toy. Ensure that is it
used under adult supervision and kept out of
reach of children under 36 months of age.
♦
Do not allow children to play with any
product packaging, such as plastic bags.
♦
Do not mix old and new batteries.
♦
Please note that the operating temperature
range is between -5°C to 55°C ~ outside this
range the display will read LLL or HHH.
♦
The operating humidity range is 20%~99%.
♦
The temperature and humidity level of the
room is not the same in all parts of the room.
We recommend that you experiment by
placing the unit in various positions to get the
most accurate reading.
CONTROLS AND INDICATORS
BATTERY FITTING
Batteries are already installed within the unit ~ to
activate simply remove the plastic strip from
underneath the battery cover.
TO REPLACE BATTERIES
♦
To open the battery cover press down and
slide in the direction of the arrow.
♦
Insert 2 x LR44 button cell batteries with
positive (+) facing up.
♦
Then close the battery cover.
N.B. If the unit displays error messages or unusual
readings please remove the batteries and re-
insert.
INSTRUCTIONS FOR USE
♦
After inserting batteries both displays will
briefly illuminate and then commence
sensing the room conditions.
♦
The correct temperature is displayed very
quickly.
♦
The humidity display will give the humidity
level after a few minutes.
♦
To turn on the backlight touch both metal
contacts on the right hand side of the sensor
with your finger.
♦
After a few seconds the light will turn off to
save power.
♦
Remove the batteries of the hygrometer/
thermometer if it is not going to be used for a
long period.
TO USE MEMORY FUNCTION
♦
Press the MEM memory button on the back
of the unit.
♦
MEM will then be displayed on both the top
and bottom half of the LCD displays. This will
then start the internal memory function ~
and will record over a period the Min/Max
Humidity & Temperature.
♦
To review the recordings; press the Min/Max
button on the back of the unit. Press once to
display the maximum humidity/temperature
– MAX will display on the screen. Press
Min/Max for a second time to display the
minimum humidity/ temperature – MIN will
display on the screen. Press Min/Max again
to display current readings.
♦
Note: pressing the MEM memory button
twice will reset the internal memory.