Valves
Your GigBob has top-quality Leafield C-7 inflation/deflation valves. To inflate the
chambers, push down on the spring-loaded stem, and turn it clockwise. This
closes the valve seat. You can leave the valve closed when inflating; air pressure
from your pump pushes the valve seat open, allowing air to enter. To deflate a
chamber, push down on the valve stem, and turn it counterclockwise. This locks
the valve open and allows air to escape. When operating your GigBob, keep the
valve cap snugly closed to keep water and debris out of the valve opening.
If your valves are not airtight, it may be due to dirt or sand that has worked into
the valve. Opening the valve on a fully inflated chamber often blows any debris
off the valve seat. If the valve still leaks, cleaning the valve should solve this
problem. First, deflate the chamber of the valve to be cleaned. Dip a cotton-
tipped swab into 303 Protectant, and wipe the inside of the valve. The rubber
plunger in the bottom of the valve is the most important part of the valve to clean.
After thoroughly cleaning the valve, re-inflate the chamber.
Maintenance and Cleaning
Avoiding or eliminating moisture inside the GibBob’s chambers is an important
responsibility of the boat owner. Any repairs on the water might unavoidably
leave some moisture in tubes. Leaving valves open in wet weather can allow
moisture to accumulate inside. Leaving any moisture in the chambers for
extended periods can cause mildew and deterioration.
If you do get moisture inside, open the chamber’s valve and dry by blowing air in
with a vacuum or pump. Exchange air several times to drive moisture out. Proper
care and maintenance improves the boat’s appearance and longevity. Clean
and inspect the boat after each use. Occasionally coating your boat with 303
Protectant increases the longevity of the fabric.
800-635-5202 |
nrsweb.com
4
© Darci Niles www
.designnaturale.com
