Stepper Motor Driver AD1431
YA7179-1/2
- 15 -
6. Handling precautions
6-1.
This driver is a natural cooling type. Put this product in well-ventilated place as possible and space
more than 10mm out around this driver.
6-2.
Do not use in place with dust, oil mist, corrosive gas, etc. Additionally, remove dust periodically.
6-3.
Do not put this driver in place with excessive vibration and shock directly
6-4.
Make sure to keep the signal line (CN2), the power line (CN1) and the motor line (CN3) away from
one another to prevent noises.
6-5.
If there are noise sources such as relays, high-pressure switching equipments or inverters, these
may cause induced and radiation noises mix in the signal lines or power lines and may cause
malfunctions. Make sure to keep the wires and driver from such noise source as possible.
6-6.
Be careful when you touch metal parts. It may result in injury on your finger by an angle of the metal.
6-7.
Do not touch the board of this product while the power is supplied. When you move, wire, maintain
and inspect this product, power it off.
6-8.
Be careful if you touch the product while the power is supplied and just after the power turns off. The
product may be hot.
6-9.
Keep this driver out of reach of children.
6-10. Store this driver in place within the predetermined range of temperature and humidity. Do not leave it
in place subject to direct sunlight.
6-11. Plug in the connectors closely. Do not insert and remove connectors with wet hands.
6-12. If smoking, abnormal smell or noise occur, shut down the power immediately.
7. Accessories
Connector for CN1
IL-G-2S-S3C2-SA (Japan Aviation Electronics Industry, Ltd) 1 pc
Connector for CN2
IL-G-10S-S3C2-SA (Japan Aviation Electronics Industry, Ltd) 1 pc
Connector for CN3
IL-G-6S-S3C2-SA (Japan Aviation Electronics Industry, Ltd) 1 pc
Contact for connectors
IL-G-C2-SC-10000 (Japan Aviation Electronics Industry, Ltd) 16 pcs
Applicable wire : AWG22 to28
The above components are attached.
Use the following crimp tools for clamping contact.
CT150-1-ILG (Japan Aviation Electronics Industry, Ltd)
Applicable wire : AWG26 to 28
CT150-1B-ILG (Japan Aviation Electronics Industry, Ltd)
Applicable wire : AWG24 to 26
CT150-1C-ILG (Japan Aviation Electronics Industry, Ltd)
Applicable wire : AWG22 to 24
or equivalent
