11
5.3 Error alarm
When a malfunction appears on the screen in the process of operation, instead of the
concentration of the measured component, the symbol "E" (ERROR) "E1"..."E9" appears
on the screen than activated a continuous light and sound alarm, which lasts about 5
seconds.
In this case, it is necessary to turn off the gas analyzer and transfer to the technical
support service.
Do not use faulty gas analyzer.
5.4 Battery discharge alarm
When the battery of the power supply discharged below the permissible level,
warning signals about the discharge in the form of a light and sound signal (continuous
sound for (5 – 6) seconds with the illumination of the display screen) and a flashing contour
of the battery icon on the display screen.
After the warning signals, the gas analyzer can work for another 25 minutes at a
positive ambient temperature or 1 minute at an ambient temperature below (– 10 °C), and
then automatically turns off with a short-term light and sound signal at the time of
shutdown.
If you try to turn on the detector after it is disconnected due to the battery discharge
by the button, there will be an intermittent light signal during the hold button , but
the detector will not turn on. If necessary, you can try switching on again only after
charging the battery for at least 25 minutes.
5.5 Switching off the gas analyzer in the measurement mode
5.5.1 Press the button of the keyboard.
15:24 08.08.09
100.2 k P а 24°С
С Н 4
E2.1
О 2
20.9 %
С О
0
P P M
Н 2 S
E3
