1.
a
IN THE BOX
b DIAGRAM
c WARRANTY
d SAFETY
e
TECH SPECS
2.
a
POWER SWITCH AND START UP
b
TOUCH SCREEN INTERFACE OPERATION
3.
a
CONNECTING fusionX TO YOUR COMPUTER
b CLEANING
c
OPENING THE BARREL
d
REMOVING THE BARREL FROM THE BASE
e
CHANGING THE NOZZLE
4. a MIXING/BLENDING
b LUBRICATION
c
BARRREL JAM
d COOLDOWN
5.
a
CONTACT NOZTEK
1. a
IN THE BOX
• fusionX - fully assembled
• Hopper weight
- This can be used to press the material in the hopper into the feed section
of the screw and is especially useful when using light powdered materials
• Torque wrench
- Used to tighten and loosen the bolts on the front and top of the block. Make sure the wrench
is set to 24Nm when tightening the top bolts and 18Nm for the front nozzle holder bolts.
• 4 x M8 35mm grub screws
(These are inserted into all four corners of the block, tightened
in turn to split the block apart for cleaning)
• 4 x M4 40mm bolts
- Used to remove the mixing blades)
• Copper grease
- When reassembling the block it is advisable to coat the thread with this anti
seize copper solution. Also when swapping or replacing the nozzle, coat the thread with the
copper slip.
• FusionX protective cover
- To be used when dismantling the block to protect the chassis from being scratched.
CONTENTS
Summary of Contents for fusionX
Page 1: ...USER MANUAL Noztek com 2021 All rights reserved...
Page 9: ......