© Noztek.com 2018. All rights reserved.
QUICK START GUIDE
1. Power on using switch at the rear of the machine, the home screen will
appear (image 2)
2.
Testing
will prompt you create settings according to the filament you
are using
3. Use slider to set
Guide Position,
in alignment with your spool (image 2)
4. Set
Motor Speed
5. Choose appropriate tolerance using the listed options
6. Return to home screen using back arrow in top left corner
7. Insert end of Filament into the hole on wheel, secure with two small
pieces of tape (as below).
Your settings will now be ready when
Auto Mode
is launched (image 1), these
will remain the default settings until you reset them.
CONTROL INTERFACE
Once power is switched on, the touch screen interface will be illuminated. The
main screen allows the user to choose the operation mode.
5
Image 1
