NVIP
-
5H
-
6201
-
User
’
s manual (short form) ver 1.1
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA sp. z o.o.
10
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA sp. z o.o.
10
2.3. Camera mounting
To mount a camera please follow the instructions below:
•
Unscrew the counter nut (
2
).
•
Put the bracket to the wall in a desired mounting place (with cable hole). Take the drill pattern
and mark future drilling holes for screws and wires.
•
Drill holes for screws, wires and base.
•
Mount the camera base (
1
) using the supplied plugs and screws.
•
Connect the camera wires.
•
Adjust camera position.
•
Tighten to the stop counter nut (
2
).
CAUTION!
Please note that the wall or ceiling must have enough strength to carry the IP Camera.
CAUTION!
In order to obtain declared degree of protection please seal the camera bracket to prevent water
getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop
-
through ones, seal them too.
START
-
UP AND INITIAL CAMERA CONFIGURATION
1
2
