NVIP-5DN3612H/IR-1P/F - User’s manual (short form) ver 1.0
All rights reserved © AAT Holding S.A.
8
1.4. Package contents
After you open the package make sure that the following elements are inside:
IP camera
230 VAC / 12 VDC power supply
Accessories bag
Short version of user’s manual
CD containing manual and software
If any of this elements has been damaged during transport, pack all the elements back into the original
box and contact your supplier for further assistance.
CAUTION!
If the device was brought from a location with lower temperature, please wait until it reaches the
temperature of location it is currently in. Turning the device on immediately after bringing it
from a location with lower ambient temperature is forbidden, as the condensing water vapour
may cause short-circuits and damage the device as a result.
Before starting the device familiarize yourself with the description and the role of particular
inputs, outputs and adjusting elements that the device is equipped with.
2. START-UP AND INITIAL CAMERA CONFIGURATION
2.1 Description of connectors and control tools
Camera NVIP-5DN3612H/IR-1P/F
1. BNC output
2. Audio input
3. Power supply 12VDC
4. 100 Mb/s Ethernet port (RJ-45 hermetic connector)
2.2.
Cameras mounting
To mount a camera please follow the instructions below:
Put the bracket to the wall in a desired mounting place (with cable hole). Taking the bracket’s
base screw holes as a pattern, mark future drilling holes for screws using a punch.
Drill holes in accordance with previously done markings and base hole placement.
Mount the camera with bracket on the ceiling/wall with three supplied self tapping screws.
Loosen nut
“A”
.
Adjust camera position.
Power camera and adjust zoom and focus.
Tighten nut
“A”
.
CAUTION!!!
The declared degree of protection of the camera relates to its housing and does not take into
account the possibility of moisture infiltration into the interior of the camera by connecting
cables. Connection cables protection through i.e. sealing up is the responsibility of the camera
installer. The manufacturer is not liable for any damages to the camera caused as a result of
failing in performing that activity by installer, which also means that camera damaged in that
way is not subject to warranty repairs
START-UP AND INITIAL CAMERA CONFIGURATION
A
