NVIP-3DN7000V/IRH-2P User’s manual (short form) ver.1.0
All rights reserved © AAT Holding sp. z o.o.
11
2.2. NVIP-3DN7000V/IRH-2P mounting
To mount a camera please follow the instructions below:
Unscrew the dome from the camera
Unscrew base from the camera’s module
(“A”
screw).
Push latches marked
“B”
in the direction pointed by arrow and move camera module up
Remove the cable, place a cable glad on it, next, screw the assembly to camera housing using
thin and thick (6mm) silicone gasket provided with choke. Please do not use the original nut,
as they are not designed for the task described above
Taking holes at the bottom of the camera’s base as
a pattern, please mark the drilling holes
for screws and cables (using a punch, for example).
Drill holes, in accordance with camera’s base hole placement.
Drill cable hole in the mounting place.
Mount the camera base using included screws.
Mount the camera module to camera’s base and lock the
“A”
screw
NOTE:
In order to obtain declared degree of protection please seal the camera bracket to prevent water
getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop-through ones, seal them too.
To adjust scene observed please follow the instructions below:
Push latches
“C”
in the direction pointed by arrow and remove cover
Loosen the vertical adjustment screws (
“D”
screws).
Point the camera to a desired scene in accordance with figures below
Block vertical adjustment screws (
“D”
screws).
Adjust zoom and focus loosening the zoom/focus blocking
“E”
screws.
Put cover onto the camera
Put dome onto the camera’s base and secure it using screws.
START-UP AND INITIAL CAMERA CONFIGURATION
B
A
B
C
C
E
D
