NVIP-2DN5041V/IRH-1P, NVIP-3DN5041V/IRH-1P, NVIP-5DN5041V/IRH-
1P User’s manual
(short form) ver.1.0
All rights reserved © AAT Holding sp. z o.o.
9
2.2. Camera mounting
1.
Use the included allen key to remove the camera cover dome screws
and remove cover dome.
2. Use the included mounting template or the camera to mark holes for
the mounting screws.
3. Drill holes in marked places.
There are two ways to mount camera:
Method 1: Direct Attach Install
4a. Remove 2 of the 3 base locking screws. Use 2 pieces of M3x72
screws to mount the camera directly to the mounting surface.
5a. Remove the 3rd base locking screw and install the 3rd M3x72
screw.
Method 2: Camera Base Install
4b. Remove the camera base by unscrewing the 3 base locking screws, and turn camera module
approx. 5 degrees counterclockwise to detach camera base from the camera module.
5b. Install the base to the correct holes as indicated on the mount template using the M4x32 screws.
6.
Ensure the rubber gasket inside the camera is properly in place, then mount the camera cover dome
and the camera cover screws.
START-UP AND INITIAL CAMERA CONFIGURATION
