NVIP-2DN3031V/IR-1P-II - User’s manual (short) ver 1.0
All rights reserved © AAT Holding S.A.
10
2.4. Installation
1. Remove locking screw from camera base and then remove camera base.
2. Put base of the camera to the desired mounting surface, and mark drilling holes using base as a
template.
3. Drill mounting and cable holes in previously selected points.
4. Mount the camera base using included screws on smooth surface providing declared degree of IP
protection.
5. Adjust the position of the camera module. If required, loosen the screws blocking camera
module.
6. Put on the camera cover again, matching screws to the corresponding holes located in the base
of the camera and screwing until slight resistance is felt.
CAUTION!!!
The declared degree of protection of the camera relates to its housing and does not take into ac-
count the possibility of moisture infiltration into the interior of the camera by connecting cables.
Connection cables protection through i.e. sealing up is the responsibility of the camera installer.
The manufacturer is not liable for any damages to the camera caused as a result of failing in
performing that activity by installer, which also means that camera damaged in that way is not
subject to warranty repairs
START-UP AND INITIAL CAMERA CONFIGURATION
