NVH-160H /230, NVH-160H/12/24– user’s manual, ver.1.0
All rights reserved © AAT Holding sp. z o.o.
9
MOUNTING
4. Mounting camera in housing
1.
Select suitable mounting location and lead all cables near the bracket.
2.
Mark mounting position and drill 3 holes for plastic anchors.
3.
Screw on bracket to the wall using 3 tapping screws with plastic anchors.
4.
Unscrew 2 screws connecting parts of the housing.
5.
Open the housing.
6.
Lead the necessary cables through the cable channel and screw on cable clamp for
cable channel sealing (seal with silicone sealant if necessary).
7.
Screw on housing to the bracket with 4 screws.
8.
Connect housing power cables to connector board maintaining proper polarization
(refer to previous page).
9.
Screw on camera to the mounting base using additional screw. Plastic mounting base
provides electrical isolation of camera from camera housing. The camera mounting
place should be chosen depending on camera-lens length.
CAUTION:
It is not advised to install camera-lens kit directly above heater
shield. Heat emitted from the heater may cause grease evaporation
from mechanical part of lens. It can damage lens mechanism.
10. Screw on mounting base with camera to bottom part of the housing.
11. Connect power and other necessary signals to the camera.
12. Check and if necessary set lens focal length and sharpness
13. Close the housing.
